I'm hoping this sounds familiar to someone. Originally had dirty dishes and soap not dissolving. Ran diagnostic and came up with 5.1, 7.1, and 8.2. Seems to be heating and draining fine. Unplugged to reset, not just 5.1 code comes on. \'Add Dish\' light stays on when I run it. It seems to fill, then sits quiet for a while. Then the pump seems to send water into the line and rumble, but when I open the door no water is dripping--its still in the bottom only. Pump runs for about a minute then shuts off. Then I hear clicking like a relay in the door every few seconds, then silent. Then pump tries for about a minute, silent, clicking, etc. When I hit cancel it drains fine. Any ideas on where to go with this? I\'m new to DIY appliance repair and don\'t want to just start throwins parts at it.