The Whirlpool Front Loading clothes washer quit while trying to wash a light load. I read the "Wash" light blink sequence as Error F5 E2 - It was full of water. The machine won't Pump Out, or Spin and the Door Lock doesn't work. I unplugged it and tried to rerun it and get the same error. I took the water pump out and it turns freely - but the motor itself is full of oil? None leaks out. I put 110 on it and it runs, but if I turned it up slowly from 30V to 120V it sometimes just hums. Starts OK if I switch the power on quick. I put the motor back together but it won't run. I have the inlet valves at the wall turned off. Can I get any action at all without water into the machine? Same error code, so far after normal turn and wait 20 sec or so. Unit is Whirlpool WFW9150WWl00, S/N HL01339245 - Is it the door switch or motor control board?