I have an LG washer / dryer, at the end of the drying cycle to stop the clothes creasing it goes into a cooling down cycle but the tub fills with water. F1480RD6: At the end of the drying cycle, when the clothes have dried, the machine enters a cooling down cycle (“Cd” is displayed) to stop the clothes creasing. But the drum fills with clean water and wets the clothes again. If left the water level exceeds the point where the door seal can hold the weight of water, and leaks past the door seal onto the floor. If you select the “Dry Only” cycle at this point the machine will pump about 1/4 of the water in the tub out. So 4 “Dry Only”cycles empties the drum completely. The water inlet solenoid valve cluster has been replaced. Both pumps have been cleaned out as have all the pipe work, but the tub continues to fill. Any ideas?